CGRCY - POLYESTER HIGH GLOSS DOT GREEN, T007-GN13
- MSDS: CGRCY
- Manufacturer: CARDINAL INDUSTRIAL FINISHES
- Product Name: POLYESTER HIGH GLOSS DOT GREEN, T007-GN13
- National Stock Number: 8010-00N083680
Product Identification
Product ID:POLYESTER HIGH GLOSS DOT GREEN, T007-GN13
MSDS Date:04/22/1997
FSC:8010
NIIN:00N083680
MSDS Number: CGRCY
Responsible Party
SOUTH EL MONTE, CA 91733
US
Emergency Phone: 800-424-9300 (CHEMTREC)
Info Phone: 818-444-9274
Preparer: RICHARD A. STEWART
Cage: 65860
Contractor
Telephone: 818-444-9274 OR 213-283-9335
Cage: 65860
Ingredients
S-TRIAZINE-2,4,6(1H,3H,5H)-TRIONE, 1,3,5-TRIS
CAS: 2451-62-9
RTECS: XZ1994900
Fraction By Weight: 3-5%
OSHA PEL N/K
ACGIH TLV: N/K
0 @ 20C.
RTECS: 9999999ZZ
OSHA PEL N/K
ACGIH TLV: N/K
0 @ 20C.
CAS: 1317-65-3
RTECS: EV9580000
Fraction By Weight: 1-5%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST
0 @ 20C.
CAS: 1328-53-6
RTECS: GE4300000
Fraction By Weight: 1-5%
OSHA PEL N/K
ACGIH TLV: N/K
NICKEL, ANTIMONY, TITANIUM YELLOW PIGMENT; (PIGMENT YELLOW
CAS: 8007-18-9
Fraction By Weight: 6-10%
OSHA PEL N/K
ACGIH TLV: N/K
<1% (VOLUME); <1% (WEIGHT)
RTECS: 9999999VO
OSHA PEL N/K
ACGIH TLV: N/K
NEAR MACHINERY OR SOURCES OF IGNITION. CNTNRS OF
RTECS: 9999999ZZ
MATERIAL IS A POWDER COATING W/LOW TOXICITY, FOLLOW
RTECS: 9999999ZZ
FLAMES OR SOURCES OF IGNITION OR SPARK
RTECS: 9999999ZZ
USE, UNLESS SEPARATED BY A PARTITION.
RTECS: 9999999ZZ
SUPPLIER.) ENGINEERING OR ADMINISTRATIVE
RTECS: 9999999ZZ
NIOSH APPRVD PARTICLE MASKS OR RESPS
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE IRRITATION AND
REDNESS, TEARING OR BLURRED VISION. SKIN: IRRITATION, RASH AND
DERMATITIS. PROLONGED OR REPEATED CONTACT MAY CAUSE SKIN
SENSITIZATION. INHALATION: COUGHING, SNEEZING, NA SAL IRRITATION.
MAY CAUSE NOSEBLEEDS. INGESTION: MAY BE TOXIC BY INGESTION.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY
CONDITIONS, ALLERGY, ECZEMA OR SKIN CONDITIONS.
First Aid
First Aid:EYES: FLUSH W/WATER FOR AT LEAST 15 MINUTES. GET MEDICAL
ATTENTION IMMEDIATELY. SKIN: WASH EXPOSED AREA W/SOAP AND WATER.
REMOVE CONTAMINATED CLOTHING AND WASH BEFORE REUSE. INHAL: REMOVE
TO FRESH AIR . IF BREATHING IS DIFFICULT, ADMINISTEROXYGEN. IF
BREATHING HAS STOPPED, GIVE ARTIFICIAL RESPIRATION. GET MEDICAL
ATTENTION. INGESTION: INDUCE VOMITING, KEEP WARM AND QUIET. GET
MEDICAL ATTENTION.
Fire Fighting
Extinguishing Media:FOAM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:THIS PROD IS A DRY POWDER & UNDER NORMAL
OPERATING CNDTNS PRESENT A MINIMAL RISK OF FIRE/DUST EXPLOSION.
HOWEVER, PROPER STORAGE & CAUTION IN HANDLING (SUPDAT)
Accidental Release
Spill Release Procedures:REFER TO OTHER SECTIONS OF MSDS. ELIMINATE ALL
IGNITION SOURCES. SWEEP UP SPILLS AND PLACE IN DRUM OR OTHER
SEALABLE CONTAINER. AVOID GENERATING DUST FROM CLEAN UP MATERIAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN A COOL, DRY PLACE & PROTECT
FROM BREAKAGE. AVOID STORING AT TEMPS ABOVE 80F. AVOID EXCESSIVE
MOISTURE OR HUMIDITY. KEEP CNTNRS (SUPDAT)
Other Precautions:POWDER COATINGS SHOULD BE APPLIED ONLY W/PROPER
APPLICATION EQUIP W/IN A PROPERLY VENTD CONTROL ENCLOSURE. POWDER
COATING EQUIP SHOULD BE GROUNDED AT ALL TIMES TO PREVENT STATIC
ELECTRICITY BUILD-UP ( OSHA 29CFR 1910.107). NO OPEN (ING 9)
Exposure Controls
Respiratory Protection:IF TLV OF PROD OR ANY COMPONENT IS EXCEEDED A
NIOSH APPRVD RESPIRATOR IS ADVISED IN ABSENCE OF ENVIRONMENTAL
CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH APPRVD DUST RESPIRATORS
UNDER SPECIFIED CONDITIO NS. (SEE YOUR SAFETY EQUIPMENT (ING 11)
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL &/OR LOCAL EXHAUST)
VENT TO CONTROL DUST ACCUM & MAINTAIN EXPOSURE BELOW TLV(S).
Protective Gloves:IMPERVIOUS GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER . WEAR
PROTECTIVE EQUIPMENT TO PREVENT EXPOSURE & PERSONAL CONTACT. (ING
12)
Work Hygienic Practices:WASH HANDS THOROUGHLY BEFORE EATING OR USING
REST ROOM. SMOKE ONLY IN DESIGNATED AREAS.
Supplemental Safety and Health
EXPLO HAZ: & USE PRACTICES SHOULD BE USED AT ALL TIMES. WHEN EXPOSED TO
EXTREME HEAT, DECOMP PRODS MAY YIELD OXIDES OF CARBON & NITROGEN OR
TOXIC FUMES. DUST EXPLOSION POSSIBLE. HNDLG/STOR PRECS: TIGH TLY
SEALED. DO NOT STORE NEAR OVENS OR SOURCES OF EXTREME HEAT. DO NOT
ALLOW POWDER DUST TO ACCUMULATE (ING 7)
Chemical Properties
Vapor Pres:SEE INGS
Spec Gravity:13.86
Appearance and Odor:GREEN POWDER.
Percent Volatiles by Volume:<1
Stability
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS, ACIDS AND ALKALIES.
Stability Condition to Avoid:EXTREME TEMPERATURES.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE,
ALDEHYDES AND NITROGEN OXIDES.
Disposal
Waste Disposal Methods:REUSE OR RECYCLE WHENEVER POSSIBLE. DESTROY
WASTE SOLIDS BY INCINERATION OR DISPOSE OF IN AN APPROVED LANDFILL
IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.